Charlestowne Woodturners

A club for those turning, or wanting to learn woodturning in the Charleston SC area.
The Charlestowne Woodturners are meeting at JMO Woodworks, 70 Romney St., Charleston, SC 29403. On the 3rd Wednesday night of each month from 6:30pm-9:00pm.
HomeHome  CalendarCalendar  GalleryGallery  FAQFAQ  SearchSearch  RegisterRegister  Log in  

Share | 

 chisel holder

Go down 

Number of posts : 7
Age : 67
Registration date : 2009-04-21

PostSubject: chisel holder   Mon May 04, 2009 2:58 pm

I need some design ideas for my chisel/accessory holder.
Back to top Go down
Dave W

Dave W

Number of posts : 290
Age : 52
Registration date : 2008-11-20

PostSubject: Re: chisel holder   Mon May 04, 2009 11:13 pm

It really depends on what you are after. You have seen mine, it works for me, however, I will probably loose the magnetic strips and creat some kind of grove for the steel to slip into instead. A couple other ways that I have seen and considered: A rolling cart with the tools upright simular to my wall mount, a simple holder that attaches to the ways at the end of the lathe, a built in system for under the lathe. I have some magazines laying around with a few plans as well, I'll try and find them and give you a call this week.

A couple links to check out:,shop.product_details/flypage,shop.flypage/product_id,20/category_id,8/manufacturer_id,0/option,com_virtuemart/Itemid,39/

Life's short, turn fast!

Back to top Go down

Number of posts : 53
Age : 71
Registration date : 2008-11-21

PostSubject: Re: chisel holder   Wed May 06, 2009 12:38 am

I just use a 1x4 with keyholes cut into it. The steel part slides thru the keyhole and stops on the handle.
Back to top Go down
Sponsored content

PostSubject: Re: chisel holder   

Back to top Go down
chisel holder
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Charlestowne Woodturners  :: Woodturning Gerneral :: Other Topics of Turning-
Jump to: